Posts Tagged ‘Frame Relay’

Frame Relay LMI Autosense Lab#02

| June 21st, 2010 | 2 Comments »

In this lab, we're going to take a look at autosensing the LMI signaling protocol. As we've seen in Lab#01, you need this to be correct in order to bring the link up. We'll start with the frame relay switch configuration. FRAME RELAY SWITCH RTR-3620#config t RTR-3620(config)#frame-relay switching RTR-3620(config)#int s1/1 RTR-3620(config-if)#encapsulation frame-relay RTR-3620(config-if)#clock rate 64000 RTR-3620(config-if)#frame-relay intf-type dce RTR-3620(config-if)#end RTR-3620#sh run int s1/1 Building configuration... Current configuration ...

Read more...
Share

Frame Relay Switch Lab#01

| June 20th, 2010 | 5 Comments »

In this lab, we're going to hit two birds with one stone. We're going to learn how to configure Cisco routers for frame relay, as well as the configuration for the actual frame relay switch. The frame relay switch will be a regular router. In this case, it's going to be a 3620 router that ...

Read more...
Share